Gas monitoring instruments are designed to protect personnel from unseen hazards that may exist in workplace environments, including confined spaces. It is vital to worker safety that these instruments are maintained and calibrated properly.
Instrument inaccuracy due to improper or irregular calibration can lead to serious accidents. Exposure to excessive levels
of toxic gas or an oxygen-deficient environment can cause workers serious illness and even death. Combustible gas explosions are
often catastrophic, injuring or killing personnel and destroying property.
The only way to guarantee that an instrument will detect gas accurately and reliably is to test it with a known concentration of gas.
Exposing the instrument to a known concentration of test gas will show whether the sensors respond accurately and whether the
instrument alarms function properly.
Causes of Calibration Drift
Over time, the accuracy of gas detection instruments can diverge from their calibration settings in several ways:
- Gradual chemical degradation of sensors and drift in electronic components that occur naturally over time.
- Chronic exposures to, and use in, extreme environmental conditions, such as high/low temperature and humidity, and high levels of airborne particulates.
- Exposure to high (over-range) concentrations of the target gases and vapors.
- Chronic or acute exposure of catalytic hot-bead LEL sensors to poisons and inhibitors. These include: volatile silicones, hydride gases, halogenated hydrocarbons, and sulfide gases.
- Chronic or acute exposure of electrochemical toxic gas sensors to solvent vapors and highly corrosive gases.
- " Harsh storage and operating conditions, such as when an instrument is dropped onto a hard surface or submerged in liquid. Normal handling/jostling of the equipment can create enough vibration or shock over time to affect electronic components & circuitry.
Often, after exposure to the more extreme conditions above, when calibration is attempted, the detector will either display a
failure message or it will not allow the user to fully adjust the display reading. At this point, the severely damaged sensor must be
replaced and/or the detector serviced by qualified personnel.
Our Technicians will design and install atmospheric monitoring equipment and breathing air cascade systems to protect your workers
from toxic and/or explosive gases and oxygen deficient atmospheres at your facility, or we offer equipment rentals to fit specific
job needs. Our technicians will come to your location to perform periodic tests and inspections on equipment already in place,
keeping your safety equipment in excellent working condition while keeping you in compliance with current regulations.
|
